Pro-series 58444 REPLACEMENT PART - WD, SHIM User Manual

Browse online or download User Manual for For the car Pro-series 58444 REPLACEMENT PART - WD, SHIM. Pro Series 58444 REPLACEMENT PART - WD, SHIM User Manual [en]

  • Download
  • Add to my manuals
  • Print
  • Page
    / 1
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
Installation Instructions
PRO SERIES SHIM (58444)
For use with Part Numbers:
49902
49901
49903
DEALERS: Please give these instructions to your
customer.
Equipment Required:
Wrenches: 1-1/8”
Torque wrench
It is very important that the shim be used when necessary to keep the system tight and prevent premature damage to the
weight distributing head.
Use the shim provided to fill any gap between the Weight Distributing Head shown below and the hitch bar used in the particular
application.
It is easier to install the shim from the top down as shown above. In doing so, you will encounter on of three scenarios:
1. Shim will go all the way down to line up with the bottom hole. If this is the case, use the entire shim in the gap.
Note: It is conceivable that in some rare combinations, two shims could be used. In these cases, contact Customer Service at 1-
888-521-0510 for a free additional shim service kit #58444.
2. Shim will not begin to fit between the head and hitch bar. If this is the case, discard shim and continue installation. The existing
gap is acceptable.
3. Shim will not go in far enough to reach bottom hole. If this is the case, cut shim in half and use only the top half for the top bolt.
Discard bottom half of shim.
© 2010 Cequent Performance Products, Inc.
Sheet 1 of 58444IN 04-25-11 Rev. A
Tighten all ¾" fasteners with torque wrench to 260 Lb.-Ft.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
49901
Max Gross
Trailer WT (LB)
Max Tongue
WT (LB)
Weight Distributing
10,000 550
Weight Carrying
Ball Mount
5,000 500
Form: F205 Rev A 5-6-05
49902
Max Gross
Trailer WT (LB)
Max Tongue
WT (LB)
Weight Distributing
10,000 750
Weight Carrying
Ball Mount
5,000 500
49903
Max Gross
Trailer WT (LB)
Max Tongue
WT (LB)
Weight Distributing
10,000 1,000
Weight Carrying
Ball Mount
5,000 500
Page view 0
1

Summary of Contents

Page 1 - Installation Instructions

Installation InstructionsPRO SERIES SHIM (58444)For use with Part Numbers:499024990149903DEALERS: Please give these instructions to your customer.Equ

Comments to this Manuals

No comments